capture start stop buttton for vintage camera taker

Based on the diagram for the relay, pins 2 and 9 represent the coil (note that there is not coil polarity). Your relay acts as a switch to connect or disconnect your remote's Ground and Shutter. Once you've got your shield ready, you can connect it to your Arduino. Look at the 12CA, the two left pins are 5V and ground respectively. The little hole near the RGB LED on the shield (the actual photo) is conveniently connected to 5V of the power of the Arduino.

I've only used Term-60 (which is ground and hooks up to pin 9 of the relay), Term-30 (hooks up to Output Signal of motion detector), and Term-20 (hooks up to pin 2 of the relay). The data sheet for the LED - RGB Clear Common Anode is provided here: The 6 screws in the upper left-hand corner corresponds to Term-60, Term-50, Term-40, Term-30, Term-20, Term-10 (from left to right). Greens hooks up to 220 ohms and to pin 11.

It looks slightly complicated, but all you have to pay attention to are these connections: RGB LED attaches at the left-hand bottom corner. The vehicle equipment remain operational while the engine is stopped.The shield in the pictures had been customized in our class to suit our needs.

In all vehicles, the warning light  on the instrument panel is lit when the engine is on standby. the vehicle speed is less than approximately 7 mph (3 km/h). If the warning light  flashes, this means that the clutch pedal is not sufficiently released The engine remains on standby if position P is selected, or if position N is selected with the handbrake engaged and the brake pedal released.įor vehicles equipped with manual gearboxes: the accelerator pedal is not depressed the brake pedal is depressed (sufficiently hard) The vehicle has set off from where it was parked įor vehicles equipped with automatic gearboxes: While driving, the system stops the engine (standby) when the vehicle is at a standstill (traffic jam, traffic lights, etc).

The system is activated automatically when the vehicle is started. This system enables a reduced fuel consumption and lower greenhouse gas emissions.

Capture start stop buttton for vintage camera taker